The most common reason a side brush is not spinning is because the motor is jammed with hair or another contaminant. Remove the screw securing the side brush to the side brush module and see if there is an accumulation of hair under the brush. Remove the debris and re-assemble, if it all works then you are good to go.
Is the Roomba side brush supposed to spin all the time?
Some other times, the Roomba side brush does not stop at once. It may spin, but not all the time. … For a Roomba that you’ve been using for a while or the once tasked with tackling dirt areas, the problem could be the same and may either require cleaning or replacing the side brush assembly.
How do I clean the side brush on my Roomba?
More videos on YouTube
- Loosen the side brush with a coin or small screwdriver. Note: Some models may not have a captive side brush screw. …
- Remove the brush.
- Remove any debris from the side brush and the post of the side brush module.
- Reinstall the side brush.
What does the side brush on Roomba do?
The Roomba side brush reaches along edges to remove dirt, dust and debris. It is easy to install and remove with the use of a coin or similar household item. Compatible with Roomba 900, 800, 700, 600, and 500 series models.
How do I put my Roomba in diagnostic mode?
Summary: Hold the spot and clean buttons down. Push the power switch. Keep holding spot and clean buttons down while the robot gives five ascending beeps, and five descending beeps. Release spot/clean and you are in diagnostic mode.
Why is my Coredy spinning in circles?
Usually the robot goes in circles when it finds an impediment to pass, and returns looking for a way out.
What is Error 2 on Roomba?
Error two (2) means the extractors or brushes cannot turn. … If the message persists after cleaning, you may need replacement brushes or extractors. Please visit the iRobot Store – Parts and Accessories or use an authorized retailer to order a part.
Why is my iRobot going in circles?
If your Roomba backs up or spins in circles, you need to run it in an open area for a minimum of two minutes. After letting the Roomba run for two minutes, it will stop and send an error message. The most common error is Error 9, which simply means the bumper is jammed with debris or dislodged.
Does Roomba have two brushes?
Experience a comprehensive clean with Dual Multi-Surface Rubber Brushes and 5X the Power-Lifting Suction* that pulls in dirt, debris, and pet hair from wherever it hides, along with an Edge-Sweeping Brush to take care of the details.