How do you fix a dump fault on a litter robot?

Why does my Litter Robot keep saying its full when its not?

Debris may cause the DFI to indicate a full drawer regardless of the waste in the drawer. Once you are done cleaning your unit, let it dry fully and then reassemble it.

Where do the magnets go in the litter robot?

pjutras: Hi, these magnets come from the Globe and must be placed in a specific position to trigger the Hall Effect Sensor in the base of the robot. This will allow the robot to track position of the globe. For further troubleshooting, we suggest you contact us via the support center.

How do I get the Litter-Robot back online?

Information

  1. Open the app and delete the current unit, even if it is offline. …
  2. Force close (swipe away) the Litter-Robot app.
  3. Unplug the Litter-Robot from the back of the unit for at least 1 minute.
  4. Plug the unit back in and allow to cycle fully.
  5. Once the unit has reached a solid blue light ready status, open the app.

Why does my Litter-Robot say cat sensor fault?

Have you ever found your Litter-Robot stopped in mid rotation and possibly with the red light blinking? … Sometimes after adding litter or replacing litter in the globe, the total weight of the globe becomes high enough that during the rotation or even while stationary (without cat inside) the cat sensor is triggered.

THIS IS UNIQUE:  Quick Answer: Why is it useful for robots to detect objects?

Where is the Litter-Robot Sensor?

The Litter-Robot is equipped with infrared emitters and sensors located above the Waste Drawer that check if the drawer is full each time the Globe returns to the Home position.

Why is my Litter-Robot wobbling?

If your Litter-Robot is experiencing a free or loose spinning gear, and no globe movement, it sounds like the set screw has come loose. Below are the instructions to tighten the set screw. … Turn on the power and watch for the flat side to rotate into the position that enables you access to the set screw.

How often do you change Litter-Robot filter?

We recommend that you change the carbon filters every three to four months depending on how frequently your Litter-Robot gets used. This is really up to personal preference. If you are noticing a stronger odor coming from the unit, it may be time to change the carbon filter.

Can you reset litter-robot from app?

Open your app. Go to “Remote” and click “Delete my Litter-Robot.” … Reset your Litter-Robot by unplugging it from the base while the unit is powered on. Wait 15 seconds, plug it back in, and allow it to cycle until the blue “Ready” status lights up.

How do you manually cycle a litter-robot?

Cycle Button + [8 Hour Sleep Mode]

Press and Release: Pressing the Cycle Button starts the Litter-Robot cleaning cycle. In order to pause the cycle, press any button on the Control Panel during the Clean Cycle. Press Cycle once again to resume the cleaning cycle.

THIS IS UNIQUE:  How much does it cost to be a robotics engineer?

Why is my Litter-Robot blinking red?

Litter-Robot flashing red light

A flashing red light indicates that the cat sensor has been activated continuously for 2 minutes or more by either too much weight in the unit or your cat not leaving the unit. Make sure your cat has left the unit, then check for excess weight, such as too much litter or waste.

How do I reset my Litter-Robot 3?

Always press Reset when adding litter, removing waste, or moving the unit.

HARD RESET

  1. Hold the Cycle button for 5 seconds. Both blue AND yellow lights are now on.
  2. Hold the Cycle button for 5 seconds. Yellow light turns off, blue light remains lit.
  3. Press the Reset button to clear this status and proceed to troubleshoot.